Go to GUI page 'Maintenance > Reset > Device Reboot', check the checkbox then click Apply button.If not, go back to step 4 and reconfigure the correct active image. Go to GUI page “Maintenance > File Management > Dual Image > Dual Image Status’, to double check ‘Next-active’ image is version 6.5.1.30.If the current-active image is 'image1', set Image Name as 'Image2' otherwise, set the Image Name as 'Image1'. After the successful file downloading, go to GUI page "Maintenance > File Management > Dual Image > Dual Image Configuration'.Ī.Do not power cycle the switch before and the success message shows up as below. To use HTTP method, go to GUI page “Maintenance > Download > HTTP File Download”, select the firmware file ‘image_xs7x8t_6.5.1.30.bin stored in local PC via Browser button, then click Apply button to start firmware downloading.For the other three methods, please check the IG and SW User Manual for details. There are four methods to upgrade the new firmware from PC to the switch.īelow are the steps to upgrade the firmware via HTTP, which is the most convenient method.Then unzip it to get the switch image “ image_xs7x8t_6.5.1.30.bin”. Download the new firmware 6.5.1.30 from NETGEAR product support Website and store it in local PC, and remember its location in the PC’s file system.The USB device must support the FAT32 file type. With other link speeds and cable types, the results are unpredictable. Cable test is effective for copper ports linked up as 10G, using Cat5e cables. Please unzip the file to retrieve the switch firmware for upgrade.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |